The Elder Wand 4 piece easy print

thingiverse

So I took the remix 3 piece done by adibadro and sliced it to a 4 part print. The reason I did this was due to one of the pieces being too tall for my printer to print vertical. I took the longest piece and sliced it to allow all pieces to fit perfectly together. This will allow anyone to print the pieces vertical using a FlashForge Creator and smaller. This will allow you to choose a higher infill and resolution as well (No supports are needed for this if you are using PLA.) Print Settings Printer Brand: FlashForge Printer: Creator Pro Rafts: No Supports: No Resolution: 1.5 Infill: 30 Notes: I'm also using the PrininZ Zebra board, so I use no rafts or supports. I just added a little purple glue stick to the bed and use a brim that is 6.0mm away from my print to help prime the extruder. My temp settings were 225C for the first layer then 215C for the rest. This allowed the PLA to go down smooth and stick better for the first layer. My bed remained at 60C the whole time. After the first layer my cooling fan was set to 100%. You want that first layer to be perfect so when you glue the pieces together the line will be invisible. I'm writing this and printing at the same time so when I finish I will post pics. So far it looks perfect.