The Fifth Element Stones

myminifactory

This is my version of the Elemental Stones from the movie The Fifth Element. They are 1 to 1 scale and were built in TinkerCad based on very good photos of the movie props. I did my best to make these as accurate as possible. The "damage/cracks" were drawn and placed as closely as possible to where they appeared on the photos of the props.   I made the stones hollow to aid in printing and I leave it up to you to cut them as you need to fit your own printers. 1 stone cut in half took 11.5 hours to print on my Mbot clone. Be sure to check out my other Fifth Element props on this site. The folder also contains an accessory to my Fifth Element stones (Elemental Stones). This piece can be printed out in translucent filament or printed then molded in translucent resin to allow you to create a table light from my Fifth Element Stones. It is designed to set ontop of any of the stones and allows you to place an LED light or LED flicker candle light in it basically turning the stones into a table light. Please be sure to only use low temperature LED lights with this cover. The cover has not been vented and will melt or distort if the lighting you use generates too much heat.