THE HELL FAST PRINTING_Ender 3 Vase Mode Drawers Ender3

thingiverse

Yes, when I saw this thing, I was soooooo thankfully to the creator (https://www.thingiverse.com/WayGroovy), as I don't have to much patience with this kind of printings, they take a lot of time for a simple square thing, and the vase mode drawers were my salvation :-) Thank you WayGroovy The original upper drawer has a problem, you can't open all the way out as it touches the Y-belt tensioner screws, so I did it in 2 pieces to fix this. The small piece is just to complete the space in the left of the drawer. Even like this, I wanted to make it FAAAASSSTER........sorry, did I said I don't have patience? XD So, I tried next: Please, note THE EXPERIMENTAL OPTIONS below are very important, as because printing in 0.28, the shape in the front to open the drawer, are gonna hang ugly. With the EXPERIMENTAL OPTIONS below, that's fixed. Gcodes _READY TO PRINT_are ready to print with an ender 3, and everything fits perfectly But if you prefer the STLs: Printing instructions, for people with not so much time or patience ;-) All these options are very important, don't forget any. Noozle: With noozle 0.4 Quality - Layer Height 0.28 - Line Width 0.8 (yes, double than noozle ;-) - Initial Layer Line Width 105% Shell - bottom layers 4 Material A resistant one, like PETg, Nylon, ABS ...your choice Speed - Print Speed: My ender 3 was printing it at 50/80 mm/s without problem, but your choice Cooling Enable Print Cooling: YES Support Supports: NO Special Modes Surface Mode: NORMAL Spiralized Contours: YES (this is like the vase mode) Smooth Spiralized Contours: YES Experimental (THIS IS SO IMPORTANT TO DO) Make Overhang Printable: YES Maximum Model Angle: 25º NOTE: The drawer 2 file “Drawer2_complet but touches the screws and can't open.stl” or upper drawer touches in the belt tensioner screws when opening and cannot slide totally out. Instead, you can print “Drawer2_-with 5mm_screws free_.stl” and the little piece “Block 5mm_To put beside the upper drawer_.stl” to put beside on the left, and complete the housing, makin the drawer perfectly going out just beside the belt tensioner screws. This 2 files, make the upper drawer in 2 pieces to make it easily slide out.