The MakerBot SpoolHolder

thingiverse

This is a SpoolHolder for the MakerBot Replicator 2, i printed it in a cr10-s5 so i didnt have to cut it and could make it in one setting. I used 2 holes in each side, that the makerbot already has but had to use slightly bigger screws and used bearings to fit in the cyllinder where the spool actually is. So: -4x M6x12(or x15 or maybe more) x) ; -2x bearing with: - inside circle: 8mm; - ouside circle: 22mm; I putted a bit of a sponge under the big support so it has a bit more pressure and stabilization. For the Fillament Cyllider i heated it with a heat gun, in the edges so the bearing would fit while the PLA molded and stayed there pretty well. The FillamentCyllinder fits at least the Flashforge spool (+/-52mm inside circle). Had to sand it a bit so it fits a bit more smoother.