The Master Sword from The Legend of Zelda BotW

The Master Sword from The Legend of Zelda BotW

thingiverse

Created as small version of The Master Sword from The Legend of Zelda Breath of the Wild. Modeled in Fusion 360 after the artwork version found at [Gamepedias Zelda Wiki](https://zelda.gamepedia.com/Master_Sword). When printed, the sword is about 75 cm (~30 inches) long. The model is cut into pieces to fit my FlashForge Adventurer 3 and its 150x150x150 print area. That means the blade is cut into four, and the handle is cut in three parts to remove as much need for supports as possible. There are two versions of the handle shaft – with and without the wrap. I was going to paint the wrap green, but decided against it in the end. So I should have gone with the version without the wrap. Quite a lot of sanding was done to finish this one, but I could have done even more. Especially where the blade parts are joined, and on the ends of the handle guard piece. Primed with a plastic primer, painted with basic spray paint and finished with a glossy spray. All of the cheapest kind. The diamond parts might be a better fit if printed a percent or two smaller, as it's a _really_ tight fit.

Download Model from thingiverse

With this file you will be able to print The Master Sword from The Legend of Zelda BotW with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on The Master Sword from The Legend of Zelda BotW.