ThermPro+ Temperature Probe Holder

prusaprinters

<p>This is the temp probe holder for a ThermPro model no. TP-19H, should fit any of the other color variants as well. &nbsp;It's a very challenging print on fdm due to multiple heights and grooves. The part has a integrated support for the lower. Turn on supports from build plate only. Once printed carefully remove supports from arm and center hole, then using a hobby knife part the lower o-ring grove off. There should be a small line with to index into and it should separate along the layer line. Its' pretty obvious when looking at the old part.&nbsp;</p><p>I removed the thermocouple from the probe body and inserted the probe into the new part after heating it up. I also secured a zip tie around the arm to insure it didn't split along the layer line. Once the hot shaft is in, its very secure. Reinsert the thermocouple and hot glue it back in place, same as it was from the factory.&nbsp;</p>