Thinner i3 mk3 spool holder

thingiverse

I designed a spool holder with a 2cm hole in the middle because my mk3's stock holder couldn't accommodate it. After searching everywhere for a thinner one, I decided to create my own. This is my first time designing something from scratch :)\r\nI only tested printing it with 40% infill, but it seems to work just fine so far. The "neck" of the holder bends slightly under a 600g spool's weight, but that doesn't concern me.\r\nTo print this, I had to use supports, which left the side facing down looking less than perfect. To prevent unnecessary supports on the arm, I added a support blocker in Slic3r PE.\r\nIt took around five and a half hours to complete this project, and I also applied a brim, though I'm not sure it was really needed.\r\n\r\nIf you have any suggestions or ideas, feel free to share them with me :)