ThinOptics Readers MagSafe Case

thingiverse

I build this case to fit my Readers at the back of my iPhone 12 with a standard MagSafe compatible case so that I can replace it to charge the Phone with the MagSafe charger. As MagSafe magnet I used a magnets which are normally used to make cases MagSafe compatible (see pictures). This magnets are less than 1.5mm thick. This new version does not need any backplate, just glue the magnets into the case and fill the space between the case and the magnets -> Et voilà I hope you enjoy it! A view tipps: * Check the magnetic direction bevor you glue the MagSafe magnets in the case * I used a two component glue to fix the magnets before I filled the space between the case and the magnets with epoxy resin. * Bring the magnets as near as possible to the case, I used just a thin layer of foil to "seal" the back side.