Thundershot SuperSnub Kit

prusaprinters

<p>Designed this as a kit to replace the over-long barrel, and tiny grip. Now your pinky isn't left dangling in the wind.</p><p>There are also 3 versions of the muzzle, Classic, Tactical, and Stubby. All three work the exact same, so you can just pick whichever one you like most.</p><p>Also included is a spring spacer. This is placed behind the spring, and slips over the top of the plunger rod. No need to remove the plunger head pin. This not only adds a bit of extra precompression to the spring (more power), but also reduces the amount the plunger tube can slide, which gives a better seal from the plunger tube to the cylinder.</p><p>And now, A hammer mod is also available. This brings the hammer back by quite a bit, making it easier to prime one-handed. It's still a bit more of a reach than a Hammershot, but it's the best I could do without requiring you to cut up the shell.</p><p><strong>Printing:</strong></p><p>PLA</p><p>1-3mm Layer Height</p><p>10-15% Infill</p><p>2+ perimeters</p><p>Everything should simply integrate directly with the Thundershot shell, and the new Grip accepts the original screws from the old Grip.</p><p>You MUST print the Spring Spacer at or below 0.2mm layer height, as the tolerances are very low, for where the spacer needs to fit.</p>