Soap Saver (Ikea Tackan) (stl and f3d included)

thingiverse

**Pitch** Kids using way too much soap? Is your sink always gooey? Look no further! The SoapSaver is here to save your family's finances! Simply clip this marvelous discovery under the pump on the Ikea Tackan, and the dispenser will only give as much soap as a normal person needs! **Printing** - the 100 degree version is best printed in PETG, 2 walls, 0% infill - the 130 degree version is best printed in PLA, 2 walls, 100% infill - adjust Z-scale in your slicer if you need more or less soap per dose. 150% fully blocks the pump, minimal dose around 130% in height. No post-printing required, just snap off your bed and onto the Tackan! Let the soap saving begin!