TI-99/4A cartridge rack

thingiverse

This model is a lightweight rack for TI-99 computer cartridges that holds four cartridges in a stack. For my first print (pictured), I had measured only one standard cartridge, but later found that I had five cartridges with two other shell dimensions that were slightly wider than the standard cartridge shell in my cartridge library (The Attack [Milton Bradley, 1980], Hangman [Milton Bradley, 1979], Disk Manager 2 [TI 1982], Parsec, Pole Position [Atarisoft 1982]). I modified my original width by adding 2mm to the width, which should accommodate the standard cart shape, the wider standard shape, and the Atarisoft cartridge shape. My draft print took approximately 15 hours on the Ender 3. Print with the open end up, no rafts or supports required.