Tiltrotor RC Aircraft VTOL Nemo V5

thingiverse

Prototyp Tiltrotor RC Aircraft 3D printed Nemo V5 I am starting to share my Tiltrotor RC aircraft Nemo V5. I will gradually give you all the information I think is necessary for its realization. I ask you to have a little patience for the creation of the documentation. Good luck with building your Nemo. Here are some important features of this design - It is important to keep the weight as low as possible to obtain good flying qualities. This is the reason why I have used LW-PLA filament for many parts. - I printed my Nemo with Simplify 3D. The 3 main fuselage parts use a multi-configuration slicer. I will give other information shortly. - The parts of the fuselage are assembled by screwing. This is to facilitate future updates and possible repairs. Technical caracteristics : Wingspan : 1205mm Lenght : 1007mm Height : 328mm Weight : 1.5kg Profil : NACA 2412 On- board equipment : - Engine : 2x Turnigy Brushless D2628-11 1100KV - ESC : 2x Castle Creation Talon 35 - Propeller : GWS tripale modified 8″x5″ (CW et CCW) - Accu Lipo GensAce 14.8V 4S 2200mAh - Servos - 2x ailerons turnigy - 2x tilt Hitec HS-225 BB - 1x elevator Hitec HS-55 - Board : KK2.1 with firmware OpenAero VTOL 1.6 - Receiver : Frsky X8R (use the S-BUS output to control the KK2.1 card) Link rcgroups : https://www.rcgroups.com/forums/showthread.php?2773733-Nemo-An-Osprey-Like-Bi-Copter-Test-Bed