Tink Pank

thingiverse

It's called "Tink Pank" because it's a Pink Tank!!!! Drogerdy 1.0 remix with "single (merged) parts" body and built in Raspberry Pi Camera front. I'm a noob on 3D modeling... Added electronics plate .stl files (bottom and top) for 9v battery, hg7881 motor controller, sunfounder quadruped robot board with arduino nano and nrf24 Print Settings Printer: Tronxy i3 Clone Rafts: Doesn't Matter Resolution: 0.1 - 0.2 Infill: 20% - 50% Notes: Printed most of it with 0.2 (low) resolution at 20%. This is good for the body parts but the cogs should go with 50% infill and higher resolution (0.1 - 0.15) and the track pieces sucked at 0.2/20% so I reprinted at 0.1/50% and this last setting worked fine. If you have the time and patience to do so, print the track pieces and cogs at the highest resolution possible and at least 50% infill. Some parts needed supports (main body for sure does)