Tiny Hawk 2 Candy Drop

thingiverse

Attached STLs are for a candy drop add-on for Tiny Hawk 2. I used Emax ES08A II servo. See Painless360 video for wiring help https://youtu.be/N69128cOFPc. Specifically, I soldered signal wire of servo to Led_stip pad on AIO (it is labeled LED on board). I used servo_tilt option in betaflight and remapped Led_strip pin (A00) to servo 1. I flew with 2s in angle mode. I recommend a simple U shaped launch stand so the drone can stay level with the candy payload suspended underneath. I slid servo into rectangular chassis and together press fit them onto the three pronged mount and glued in place. A tight fit will squeeze servo from side. I didn't even have to glue my servo in place. I added a little "T" to side of chassis to aid with cable management. Assembled add-on fits between FC and plastic battery holder of stock Tiny Hawk. One fun size candy bar on top of a 2s battery ended up being the perfect fit. It flies like a drone that is twice as heavy as it should be and it burns through batteries but it's a ton of fun.