Tiny Whoop 30 Degree Universal Camera Mount

thingiverse

This is a universal camera mount for any Tiny Whoop aircraft based on the Inductrix frame design. This mount is designed to be lightweight, easy to install, and work with virtually any AIO FPV camera. I tried a number of Whoop camera mounts from Thingiverse, and nothing worked quite the way I wanted. Most were designed with particular cameras in mind and were either too large or too small. This mount is designed to work with just about every camera out there. It has been tested with the VM275T and the BetaFPV B01 camera, and should work with anything else. This mount is designed to give maximum airflow over the camera as well as leaving the buttons and frequency indicator lights open. In a crash, this is designed to let the forces snap the rubber band rather than transmit force to the camera. I recommend printing in ABS or PETG as VTXs can get hot enough to potentially melt or deform PLA. The mount is secured with the normal screws for the flight controller. The camera is fixed to the mount with a small elastic hairtie that you can get from just about any store. Alternately, a rubber band may work as well. Attach the band over the camera lens assembly as shown in the images. This is designed for a 30-degree camera angle suitable for Whoop racing. If you're used to flying with a lesser camera angle, it takes a little practice getting used to flying with a 30-degree tilt, but you quickly adapt and I've found it's the ideal angle for racing.