Tippi Tree Custom Case

thingiverse

I wanted to put together a custom case for my Tippi Tree set, and most of the ones I found were either a mess (just a random box) or you had to pull everything out to get to the main tree. With this box, you pull out the tree, and aside from Earl, everything can be pulled out without disturbing anything else, and even Earl isn't that difficult to get to. This container will hold 48 leaves (4 sets of 12), 6 tall branches, 6 short branches, 3 wide branches, the tree itself, Earl and instructions (which I forgot to add in the picture). This container has only been tested on the original version of Tippi Tree, however the "block" version should work just as well as everything is still the same outer dimension. I printed this with Overture PLA, .2mm Layer height and 10 infill. The lid that I printed had a slight mishap with the cooling fan, which caused some roughness on the embossed design on the inner part of the lid. As long as your tolerances are decent, you should be able to simply print this and go, no supports needed.