Titan Amigo! A Dual Extrusion E3D V6 Additional Mount for 'the Squall' Titan Aero Mount

thingiverse

I got bored again... and combined a couple of 'things' to make another 'thing'. This mount attaches on to the stepper motor machine screws. You will need longer M3 screws than whatever size you have in there. This mount will ONLY work if you have a 40mm deep nema 17 installed. The old version the Titan Aero used to ship with was a 25mm pancake motor and this will not fit unless you make some stand-offs for the mount. **IMPORTANT** - Check clearance from your V6 hotend to the X-axis endstop housing. It should clear by a couple of MM, but be aware. May well fit other mounts where the stepper is on the printhead, so feel free to try this out. My "Squall" Titan Aero mount can be found here: https://www.thingiverse.com/thing:2854008 the Fan mount / housing can be found here: https://www.thingiverse.com/thing:895762 It is awesome, and works perfectly! I needed to superglue this on to the V6 mount to stop it from moving about though as it was a little loose. Dual Extrusion Frog can be found here: https://www.thingiverse.com/thing:329436