TMNT Toon Logo Magnet Display Teenage Mutant Ninja Turtles

cults3d

I have created the Teenage Mutant Ninja Turtles cartoon logo into a magnet/shelf display badge. These files/models have been created for use with a Dual Color/Hotend 3D printer or an IDEX 3D printer. I personall have the Sovol SV04 IDEX 3D printer and print this with no problems. The printed pieces consist of 2 physical pieces with 1) the black outline with green letters and 2) the red trapezoid banner with white letters. Black filament spool in hotend #1 and green in hot end #2. Red filament spool in hotend #1 and white in hotend #2. After both dual colored pieces have printed, super glue the red/white piece in place on the black/green piece. Super glue the magnets into their cutouts on the backside. I use Cura to merge the 2 colored stl files together. A total of 2 magnets are used. The magnets used for this diorama can be purchased using this Amazon link, https://amzn.to/3BBmX4b Also included in the downloads section is the shelf display stand which prints in 5 total pieces and can be printed all at the same time arranged on the bed. I used friction tape along the contact surfaces with the logo badge to keep it from slipping off. The stand is pretty simple to assemble. Here is the Amazon link for the friction tape, https://amzn.to/3xsnt2O Supports are not needed, even for the 2 magnet cutouts on the backside, no supports needed. I printed everything at 0.2mm layer thickness. I set the black infill to 10% with green to 20%. I set the red infill to 10% with white to 20%. Black/green piece prints in less than 9.5 hours. Red/white piece prints in less than 2.5 hours. The final dimensions are 271.42mm in length and 97.64mm in width and 7mm in thickness. The black layer is 4mm thick, green layer 3mm thick, red layer is 4mm thick, white layer is 2mm thick.