Toad 110 Remix - AIO FPV (Brushed 8.5mm Motors)

thingiverse

This is a remix I did off the original Toad 110 by charlesgershom. Modified features: -- Added a 20 degree incline on the lower deck for a CAM+VTX similar to the Eachine TX02. -- Added a slot on the top deck for the VTX antenna mast to pass through. -- Added another cross support on the top deck toward the rear for top mount battery support. -- Moved back some elevated areas on the lower deck so longer flight controllers sit flush. -- Removed battery mount pegs from lower deck and instead using velcro to mount battery. -- This camera mount design will limit damage to your VTX antenna since if it bends, it will only bend as far as the top deck, which is a few millimeters away. Required for Frame Assembly: 4x M3x18mm standoffs (or +/- 2mm) 4x M3 Nuts 4x M3 Screws Recommended Budget FPV Setup: -- Flight Controller: Hubsan X4 H107 OEM -- Motors: Hubsan 8.5x20mm OEM -- Props: Hubsan H107 OEM -- Camera: Eachine TX01 25mW AIO -- Battery: 1S 500mAh Recommended FPV Racing Setup (1S battery): -- Flight Controller: F3 Evo Brushed, Beef's Brushed, Micro Scisky -- Motors: Spintech Sidewinder 8.5x20mm (1S) -- Props: Walkera QR Ladybird or Afunta Hubsan Transparent Props -- Camera: Eachine TX01 25mW AIO (indoors) / Eachine TX02 200mW AIO (long range outdoors) -- Battery: 1S 500mAh Recommended FPV Racing Setup (2S battery): -- Flight Controller: F3 Evo Brushed, Micro Scisky -- Motors: Spintech Sidewinder 8.5x20mm (2S) -- Props: Walkera QR Ladybird or Afunta Hubsan Transparent Props -- Camera: Eachine TX02 200mW AIO -- Battery: 2S 400mAh ASSEMBLY NOTE: Use hot glue or two tiny zip ties to hold down the camera. When using the Camera+VTX AIO module, the top deck is much higher than the original Toad 110. This will require observing clearance between the props and top deck (and possibly the VTX antenna. Motors may need to sit higher in the motor mount cup, so don't shove them all the way in upon assembly until the clearance is checked with a motor that has a prop installed. I don't have any Walkera QR Ladybird props to check the size, but the Afunta props will fit and allow for free rotation. Print Settings Printer Brand: PowerSpec Printer: PowerSpec 3D Pro Rafts: No Supports: No Resolution: 0.2 Infill: 40% Notes: ABS with 40% or higher infill on the lower deck is strong enough to survive most crashes. This chassis is pretty thick and strong. Post-Printing File Antenna Slot Test fit your Camera+VTX AIO module. I had to file the slot a little bit where the antenna goes through the top deck since the heatshrink on my antenna mast had too much friction to slide in smoothly. YMMV