Toilet Seat slide-preventer / alignment block (parametric, customizable)

thingiverse

Replacement toilet seat bumpers that feature a hook to keep the seat securely in place even after a "hard landing". They help prevent damage to the bolts and hinges when someone applies heavy sideways force to the toilet seat. Note: This design is only compatible with toilet seats featuring removable feet/bumpers, which have two pin holes. There are existing similar designs ([here](https://www.thingiverse.com/thing:2216930) and [here](https://www.thingiverse.com/thing:663442)), but this one hooks on the outside instead of the inside for better cleanliness. To use these bumpers, you'll need to gather some information to customize them for your toilet seat. Remove a bumper from your toilet seat and measure: * The diameter of the pins * The distance between the pins (center-to-center) * The width, length, and height of the bumper (excluding the pins) * The distance from the outside edge of the bumper to the outside edge of the toilet bowl Customize the design and print. You'll need one "clip" and two "pins" for each side. Insert the pins into the holes on the printed "clip". It's best to insert them with the rounded end facing outwards. If necessary, use a small knife to trim around the edge of the holes first, depending on how much "squish" your printer has. Insert the entire assembly into the original bumper holes, making sure the flange faces outwards towards the toilet. Close the seat and check that the flange is at the correct distance from the outside edge of the toilet bowl. It should touch or come close but not be too tight.