TomTom GO mount for MINI cluster display

thingiverse

Mount your TomTom GO (2013) to your cluster display! I've created this mount to install my TomTom GO 600 in my MINI Clubman (2009). It will also fit other TomTom GO's and MINI's, but you might want to check yours before printing and installing this. Follow the instructions carefully and have a look at the pictures. Suggestions are welcome. Have fun! Note: -- Install with care at your own risk: I cannot be held responsible for damage to your stuff. Instructions Parts needed: -- 1pc 4x18mm wood screw 2pc ?x??mm Allen screws (Dutch: cilinderkopschroeven) 1pc original TomTom GO Click & Go Mount Tools needed: -- Screwdriver (Torx and Philips) Sanding machine Installation instructions: -- Print the mount. Screw the wood screw in the back of the ball to give the joint some extra strength Remove the TomTom GO mount from the suction cup ball. Attach the TomTom GO mount to the printed mount. You may need to sand the ball a bit to make a snug fit. Sand of the sharp points of the Allen screws. Go to your car Place the steering wheel in the lowest position possible. Disassemble the cluster display by unscrewing the top 2 screws. Move the cluster display forward to unlock it from its position . Remove the top and most right screw of the back of the cluster display. (Actually you could mount it both left and right, but I've installed mine on the left side) Attach the power cable to the TomTom Mount (once installed, it will not be that easy to plug in anymore) Put the printed mount in place and use the Allen screws you prepared to fix it to the cluster. Screw the cluster back in place. Guide the power cable nicely along the dashboard to the center console and plug it in. Snap on your TomTom and you're ready to GO! Be careful when unmounting your TomTom, since the joint is more flexible, you might want to hold the mount with one hand and remove the TomTom with the other.