Tool Caddy

thingiverse

This is a custom tool caddy I designed specifically for the tools I use most often working with 3d Printer that have been added to the set that came with the printer. Went a long way to cleaning up the desk and helping me find stuff. Added https://www.thingiverse.com/thing:3026123 to the side to hold the standard and most used Couple issues with this version that I would correct (I may correct and post an update later) - Numbering on the tip holder is a bit too high and too large - Left a typo where it should be 0.4mm its 0.1mm - Should have had more spaces for 0.4mm not sure what I was thinking - Had some warping on the bottom edges as PLA cooled, would increase bed temp a bit and use rafts - THe two empty holes on the top right were supposed to be deeper (only about 20mm deep) so I will use them for holding screws or something.