Toothbrush and -paste organizer

prusaprinters

<p>A organizing system for your toothbrush and -paste.</p> <p>I like to keep my toothpaste always ready to go, so I use a document clip to keep the good stuff near the exit. This also perfect to hang them instead of stuffing them in a glass or cup.</p> <p>In the case of the toothbrushes I wanted a system that is easily cleanable and nice to look at. Extra points for recycling. So this one uses a glass jar from some guindillas I bought at Mercadona. Basically any jar with an outer diameter of 72.5mm (measured without the thread) should fit. Make sure the original lid has 6 prongs that engage with the thread.</p> <h3>Print instructions</h3><p>Print <code>brush_tap.stl</code> with support with 40°, it's only necessary for the little bridge for the glue surface.</p> <p>Glue the <code>brush_tap.stl</code> to the <code>brush_base.stl</code> (best with 2k-Epoxy-Glue) and attach to any glass surface with double-sided tape. Do the same with the <code>toothpaste_holder.stl</code>.</p>