Top lead screw bearing holder - Photon Mono X

thingiverse

BE WARNED, ADD AT YOUR OUW DISCRETION. Adding a fix point to the lead screw may affect the movement of the linear rails and effectively the print quality I made this because the lead screw had a angular movement or wobbling that i didn't liked, I had made changes to the motor and added a coupler to connect the lead screw. In the end, I let loose because the rails were making noises. It may not be the case for a new printer but I refurbished the one i got, more info on https://www.reddit.com/r/AnyCubicPhotonMonoX/comments/wrxgxe/update_2_found_a_broken_photon_mono_x_on_a_outlet/ Another thing, I'm not sure if it will reach the lead screw of a new printer because the lead screw I used is longer It is design to use a skate board ball bearing 608RS, its a thigh fit so it must enter evenly. I recommend using a flat surface, other wise you may try placing the bearing on the freezer to cool down and shrink. It may not be much but it may help Other wise u can use the same screws that the top plate was using