[Topology optimized] VESA Extension/Riser for 100 x 100mm (Dell monitor to monitor Arm)

thingiverse

# What? Designed up this **Topology optimized** vesa mount extension to raise the height of my monitor Dell S2721dgf. # Why? The max height of my vesa monitor stand is too short, and I needed to raise the monitor up by another 30mm. Traditional vesa extensions on thingiverse do not fit this monitor due to the monitor's bulbous rear casing. # Printing: Printer: Stock ender 3v2 Material: Generic PLA Layer height: 0.4mm Print speed: 100mm/s Support: Yes Infill: I used the topology optimized mesh to generate a infill mesh in Cura. For this overlapping mesh, the infill is 60%. Otherwise, 20% elsewhere. Use M4 screws and nuts to attach to your monitor and monitor stand. Takes around 10-12 hours to print depending on your settings.