Totoro Magnetic Key Holder

thingiverse

Based on Totoro by Joo (http://www.thingiverse.com/thing:12146). Hang your keys on this wall mounted magnet Totoro! I added a mounting bracket and a plate on the bottom of the original model. CAUTION! Please read instructions carefully to avoid damage to your print head by the rare earth magnet! Instructions Instructions: Needed: 1 rare earth magnet a screw/anchor for mounting Print until the job is about 50% done. Pause the print. CHECK that the print head is much higher than the height of the magnet. I recommend at least triple the height of the magnet. Place a small amount of strong glue (epoxy or Gorilla Glue) inside the Totoro to hold the magnet. Place the magnet inside. VERY IMPORTANT: Allow the glue some time to harden or the magnet will stick to the print head ... not good! Once you are sure the magnet will stay in the model, resume the print job. Once the model is complete, put glue on the head of the screw you will be using to mount the model to the wall. Slide the screw into the model's mounting bracket. When dry, screw the model into the wall anchor and enjoy!