Tough, Easy & Customisable Snorkel Clip

thingiverse

There are other clips on thingiverse however they seem to either require a lot of support material (and clean-up) or are too thin in critical areas which is why your clip probably failed in the first place... This clip suits snorkels with a round tube, though it is possible for it to work on a slightly oval-shaped tube. The clip for the straps is also customisable for different strap widths and thicknesses. The included STL is suited for a 27mm diameter snorkel but may fit others of slightly different sizes without modification. Print Settings Rafts: Doesn't Matter Supports: No Resolution: 0.2 Infill: 100% Notes: Tested with ABS. Post-Printing There are two small pillars that act as support for the overhanging part of the clip. These need to be cut out and is easily done with some sidecutters. If these are not removed then it will be difficult (or impossible in some cases) to attach the clip to the mask strap.