Towel Holder for Oven handle

thingiverse

This is a towel holder for the bar on my oven. I was tired of towel slipping off the round oven handle, so I made a clip. It has a hole that narrows into a channel; you take the corner of your towel and put it in the hole and slide it into the narrow channel. You can change the settings in the scad file using OpenScad to fit a different diameter handle, make it a little shorter, use less material, or maybe a square handle. It's a bit of a mess but not too hard to figure out. Original version just had the clamp and a flat piece for the circle & slot; but it was weak around the hole since there's little material there and it has to support a rag that might get pulled on, so I made it taper and have more material to prevent snapping.