Toy Airplane

pinshape

Toy Model Airplane Easy to assemble and print airplane.  Very little support material required.  Print Settings Suggested Material:PLA 50mm/s 0.15mm layer height and 40% fill on body parts 0.08mm or less layer height, 90% fill on axle and prop shaft Support suggested for prop. Remove built-in support on bottom part 0.06mm 30mm/s, 20% fill for Ninjaflex Tires Additional Instructions The model is assembled using off-the-shelf 4-40 screws which can be found at any hardware store.   4-40 1/4" Screws: 11x 4-40 1/2" Screws: 3x The tires can be printed from Ninjaflex or similar TPU.  A hub+tire combined part is provided if Ninjaflex is not available.  In this case, print the Hub_Tire part in regular PLA.