Toyota 60-series Land Cruiser Cup Holder

thingiverse

This is a cup holder insert I whipped up that fits in the front compartment of the factory 60-series center console. It has two cup holders and a center slot to hold a smartphone vertically. The cup holders securely hold cans up to 23oz, 20oz soda bottles, and anything else up to 72mm in diameter. The phone slot holds my Galaxy S6 with no case with plenty of wiggle room, and should fit cases up to 72mm wide and 10mm thick. It could probably be scaled to 102-103% for a little extra room, but I haven't tested that yet. It's secured in the compartment by velcro, but double-sided foam tape or magnetic tape would also work. I also lined the bottom of each section with adhesive foam to reduce noise from my aluminum water bottle vibrating, which is optional but recommended. Enjoy! Print Settings Notes: I rotated it 2 degrees with supports underneath to print the top in a single layer. This is optional, but makes for a nicer surface finish depending on the layer height you use.