Tradfri Switch Enclosure

prusaprinters

<p>This is an enclose for an IKEA Tradfri switch. IKEA launched a series of IoT products, the switch can be hacked and connected to eg a Wemos Mini programmed to issue MQTT commands.</p><p>Based on <a href="https://www.thingiverse.com/thing:709619">https://www.thingiverse.com/thing:709619</a></p><p>&nbsp;</p><p>Search youtube for</p><p>IKEA Tradfri IOT Smart Lighting System Hack</p><p>by Andreas Spiess (video 140)</p><p>for more details.</p><p>Removing the switch from its original enclosure can be destructive, so a new enclosure is needed. I modified a small bowl (shaving), and added a slot and groove to allow a usb lead to be inserted into the base.</p><p>The fit on my printer is a snug interference fit, and no glue was needed to hold the switch in place, and there's a series of small internal indentations (from original shaving lid use) where the original switch clips can just fit in.</p><h3>Print Settings</h3><p><strong>Printer:</strong></p><p>Anet A8</p><p><strong>Rafts:&nbsp;</strong></p><p>No</p><p><strong>Supports:</strong></p><p>No</p><p><strong>Resolution:&nbsp;</strong></p><p>0.1mm</p><p><strong>Infill:</strong></p><p>10%</p><p><br>&nbsp;</p><p><strong>Notes:</strong></p><p>&nbsp;</p><p>I printed this at high resolution for a better finish, but it's not really critical.</p><p>A good fit on my printer, but tolerances may vary between machines, and you may need to sand, glue, or enlarge/shrink the print as required.</p><p>&nbsp;</p><p>&nbsp;</p><p>Category: Electronics</p>