Trading Card Box - Version A

grabcad

At 9 inches long, by 2.56 inches wide, The box is intended to store a small collection of trading cards that have been sleeved in KMC Hypermat penny sleeves, without much side-to-side movement.The interface between the top and bottom halves of the box requires some finishing/sanding post print, as once assembled, the box is very difficult to open due to minimal assembly clearance, as well as both halves having the layer-line orientation. Sanding with a 100 grit and progressively working down to about 220 grit sand paper will knock down any rough surface, while slightly increasing assembly clearance. Additionally, my prints begun pulling off of the print bed on the corners of the box. This may have been due to a dirty print surface, or poor print bed temperature calibration, and it is therefore recommended that the print surface be thoughtfully cleaned and a brim be printed to help prevent any lifting that may occur.