Traeger Ranger Adjustable Feet Legs

thingiverse

Adjustable feet / legs for the Traeger Ranger tabletop pellet grill. This replaces the square rubber feet that ship with the grill as standard and allows for some adjustablilty when using on a non level surface such as your tail gate or picnic table. I have tested this at 450F tempetaures and have not seen any issues with the plastics softening. I recommend printing in PETG and the pictures you see are in fact PETG printed. For all four feet / legs you will need to print the following: 4 x Tra Ranger Foot 4 x Tra Ranger Leg (Supports Needed) 4 x Insert Holder Nut 4 x Insert Holder Bolt To reduce stringing, print one part at a time. To assemble you will need: 4 x M3x20 Bolts 4 x M3 Nuts Insert the nut into the Insert Holder Nut component and use the M3 Bolt to run it down into the the holder before assembly. Once assembled, do not over tighten....just gently snug it down. Support needed on Leg only.