Traktor S8 Tempo Knob

thingiverse

Somewhere between gigs, I lost my tempo knob. I 3d printed some new knobs. Here's a new tempo knob for the Traktor S8, although I bet it would fit on most of their hardware. I included the .f3d files so you can adjust the height and width of the knob as needed. I think that all of the encoders / pots on the traktor mixing hardware are the same shaft diameter, FYI. I printed this one in NGEN PLA at 0.01 layer height on the Ender 3. At .02 layer height I found the internal diameter of the knob needed to be increased from 6.25 to 6.5mm although YMMV.