Trampoline Net Holder

thingiverse

This is the piece used on a trampoline, which holds the net to the top of the poles. It was designed to be in close comparison with the original piece that came with the trampoline. These however fit very snug in case you no longer have the retaining screw. I had to hammer it in the rest of the way, but this ensures that it will not spin or fall out. If you do still have the screw, then there is also a hole in place which will guide the screw in. This piece was made to fit popular trampoline models found in Wal-Mart and K-Mart. The web picture I included says models around 2010 and 2011, but my trampoline was purchased in 2016 and it fits all the same. Let me know how it works or if you run into any issues. Print Settings Printer Brand: PowerSpec Printer: PowerSpec 3D Pro Rafts: Yes Supports: Yes Resolution: .2 Infill: 50% Notes: External supports. I used 50% infill to make sure it was strong, but you can probably get away with much less. 1 shell. Feed rate 40 mm/s travel 45 mm/s. PLA. bed temp 50. extruder temp 220. The print took approx. 3 hr 40 min with above settings.