Transformers COMBINER WARS Posable Hands

thingiverse

!!! NEW VERSION OF HANDS IS VAILABLE HEREhttp://www.thingiverse.com/thing:1822735 THEY ARE SNAP-IN AND FULLY BALLJOINTED. ENJOY!!! Articulated hands for Combiner wars style Gestalts and any other that attach on a 5mm peg. not suitable for holding 5mm peg guns. note - printed on my ultimaker original plus, this design requires some proper fine tuning like re-drilling the holes for the steel rod, cutting the rod in pieces, there might be some friction issues that will require sanding/filing. You need to mirror the hand body in your slicer to get the other hand done ;) the hinges for all fingers are universal, so you will need 5 per hand middlefinger section is also universal, you need 5 per hand fingertips - 1 short for thumb, 2 long for middle and 2 regular for sides 1 peg per hand if you need to have the holes re-drilled i recommend a hand drill of 1mm, anything faster than very slow will cut through like butter (temperature) Print Settings Rafts: No Supports: Doesn't Matter Resolution: 0,1 Infill: 100 Notes: i get best results with PLA, on UMO+ with this setup temp: 215 c bed: 50 c layer hight: 0.1 shell: 0.8 bottom/top fill: 0.8 infill: 100% print speed: 30mm/s (speed applied to ALL categories of printing/travel eg. infill, shell, top, bottom) support type: everywhere for hand body only, none for fingers and hinges platform adhension: brim - 20 lines PRINT ONE AT A TIME - enabled, otherwise you will get horrible stringing