Transformers Hitch Cover with Tabs

thingiverse

Modified the Decepticon 2 and Autobot 2 Trailer Hitch Covers by Djkirkendall to use spring tabs. For 2in hitch receiver. S3D Users: There's something causing a gap between the back of the faceplate and the hitch cover that leaves a large area to bridge over which can cause a print failure. A workaround is to go into the Mesh menu and select Separate Connected Surfaces. Then reslice and it should be good to go. Update: Thinned and elongated the tabs so it's less likely to break off.