Trash Container for Supports and Painter's Tape

thingiverse

I had lots of support material and painter's tape all over my 3d printing space, so I designed this model using Tinkercad to keep my area clean. The model is very sloppy in the pictures as a used .4 mm layer height and did not bother to clean up the print or use supports since it is just a garbage can essentially and will not be on display. Please enjoy this model if you decide to print it. Print Settings Printer: XYZ Da Vinci Jr Rafts: Doesn't Matter Supports: No Resolution: .4 Infill: Not necessary because walls are too thin Post-Printing I used a sharpie on the text to make it easier to read and look nicer.