Travel Mug iPhone Holder with USB Cable

thingiverse

Designed for my Chevy Volt, where the USB charger cord in inside the console right next to the cup holder. I Wanted to be able to easily view my phone safely while driving as my base model does not have navigation built in. Designed for an iPhone 6 with an Otterbox case, it will probably fit many iPhones with most cases that aren't too thick. Would probably work for any phone with a bottom charging plug that is in the center with little or no modification. See dimensional document for size specs. 6/5/16 - If you cable pulls ount periodically due to a tight fitting phone jack, use the shim I added. this piece goes in from the top with the tapered side down and curve along the body of the plug. Some gentle coaxing and it pins the connecter and flushes up the to the bottom of the trough. Of course one could simply glue it in as well but where's the creativity in that :-) Print Settings Printer: XYZ Pro Rafts: Doesn't Matter Supports: Yes Resolution: Fast Infill: 15% Notes: NOTE!! This was designed for a particular lightening cable. I compared it to another and the molded body were slightly larger. The larger plug could have been ground down to fit but just be aware that ll lightening connectors are not the same and yours may not fit as-is. Unfortunately, I don't have a brand of the one I used so I provided the measurements of the printed receptacle.