Travel Mug Jacket

thingiverse

This travel mug was not holding in the heat very well so I made a jacket out of TPU. * Two parts because the widest diameter of the mug is part way up and the jacket is intended to fit snugly. * Text added as a customization. The SCAD files can be edited in OpenSCAD.. * The jacket ends at a level below the lowest part of lid so that it does not interfere with screwing the lid on or off. * The mug is inserted into the bottom of the jacket. * The top on the jacket is lowered over the mug when the lid is off, A little force is required. * The top and bottom parts are made to overlap by one cm. There is enough friction to hold pars in place. Intentional force can remove jacket for cleaning.