Traxxas Rod Jig for 40mm V Slot Aluminum Extrusion

thingiverse

This is a remix of Thews'/Justin Edwards' traxxas rod jigs for 1 or 3 rods. I personally recommend doing 1 rod at a time, using the center slot in the jigs. However, if you want to do 3 at a time, be sure to test fit well to make sure that the jigs are perfectly lined up, to prevent any kind of differences in length between the top and bottom rods in the jig. 8/24/2016 - I only had 16mm m5 bolts which were bottoming out with the original 7.5mm thickness of the mounting bracket. I extruded the thickness by 5mm for version 1.1. 8/28/2016 - Though the single rod might be more consistent, I am impatient and figured others might be too, so I made a 3 rod version as well. You can also just print the 3 rod jigs and just use the center slot still if you want to be more precise. In the end its probably a little less plastic.