Traxxas TRX4 rear steering servo mount

thingiverse

I printed this with 100% infill because the time difference was a matter of an hourish and I figured what little weight down low would help the trx4 out. This is used along with a front axle in place of the stock rear axle in the trx4. I have used a shorter servo arm such as the one in the image from losi as well as a tie rod I had sitting around from my bandit drag car conversion. If you print this please give me some feedback on the design, the only thing I believe I left out of the design was a hole for the upper arm mounting bolt I may change it up again but I don't think it effects it very much. went for strength more than this bolt hole.