Tray for single D10 die, life counter

thingiverse

I wanted a tray for a D10, but I found most of the ones available were overly complex. I designed this one to hold a single die sitting flat, which meant I didn't need to have any material under the die. I created two versions: the "tall" one is very secure; though the die fits loosely it can be tipped almost vertical before the die falls out. Good for protecting from accidental changes. The "short" one is easier to pick the die up to change the displayed number. The (fairly simple) OpenSCAD source is attached so changes can be made if needed. As is, it fits the standard 22mm (point-to-point) dice that my local gaming store sells loose. It would be very easy to remix to make a set for multiple dice. I printed with minimal infill but I think it may just be possible to print with no infill if you were careful aligning the bridging on the top surface.