Treasure Chest Remix

thingiverse

I remixed the "Treasure Chest" by cushwa with the hinges of the "Hinged Treasure Chest with Latch" by cymon, scaling it up 2.5 times to fit a treasure hunt bounty I printed for. The chest was uploaded the wrong size initially (too small by 2.5 times), so I also uploaded a "correct_size" version now. The hinges were designed to allow the lid to be left open in an upright position, as shown in the third photograph. This design choice means the lid doesn't open any further than that. Printer settings include using a Cubicon Single printer with no raft or support material. The resolution is set at 0.3 mm layer height and infill is 15%. Notes indicate that the chest and its lid were printed in Polymaker Polywood without supports, giving it an old weathered look. The padlock was printed separately at 0.15 mm layer height using black Cubicon ABS material.