Trinket plate/bowl and decorative plate stand.

prusaprinters

<p><strong>Plate - 2hrs 24min</strong></p><p><strong>Plate Stand - 41hrs</strong></p><p>My first major design and print with CAD software.</p><p>The plate and plate stand comes out very nicely, however the plate stand does require a copious amount of support, which did take 2hrs to remove. Regardless, I was pretty happy with the final result. Feel free to remix this print to make it a more time feasible print.</p><p>&nbsp;</p><h3><strong>Print Settings&nbsp;</strong></h3><p>Printed using Cura on an Ender 3 v2.</p><h4><strong>Plate</strong></h4><p>Quality: 0.2mm</p><p>Walls: 1.2mm (3 walls)</p><p>Infill: 10% using Gyroid</p><p>Material: PLA</p><p>Speed: 80mm/s</p><p>Cooling: 100%</p><p>Support: none (will result in layer shift, use standard supports if you don't want this)</p><p>Build Plate Adhesion: none</p><p>Other notes: Use monotonic top/bottom order (only for the plate)</p><h4>Plate Stand</h4><p>Quality: 0.2mm</p><p>Walls: 1.2mm (3 walls)</p><p>Infill: 10% using Gyroid</p><p>Material: PLA</p><p>Speed: 80mm/s</p><p>Cooling: 100%</p><p>Support: Tree&nbsp;</p><ul><li>Tree Support Branch Angle: 40</li><li>Tree Support Branch Distance: 1.0</li><li>Tree Support Branch Diameter: 2.0&nbsp;</li><li>Tree Support Diameter Angle: 5.0</li><li>Tree Support Collision Resolution: 0.2</li><li>Support Placement: Touching Build plate</li><li>Support Overhang Angle: 45</li><li>Support Density: 2.0% (Without support density my supports would fall over)</li></ul><p>Build Plate Adhesion: Raft</p><p>Other notes: RIP fingers from removing supports if you are daring enough to print this.</p><p>I used pliers, scissors and my hands to remove the supports.</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p>