Tripod Adapter

prusaprinters

<p>This is a mounting adapter I made for a Yagi antenna. One mount works with an <a href="https://www.amazon.com?linkCode=ll2&amp;tag=thingiverse09-20&amp;linkId=e4759bff1fa9a55a0f897d801ce2d765&amp;language=en_US&amp;ref_=as_li_ss_tl">Amazon</a> Basic's Camera tripot, the other was designed to clamp onto a pole (in my case the coat rod in a closet.</p> <p>The center holes were designed for a 5/16" head head bolt and wing nuts.</p> <p>The holes that put the L-brackets together are M4, while the antenna and rod brackets are M5.</p> <p>I put a fender washer between the printed piece and the wingnut. I tried putting a fender washer between the printed pieces but that doesn't allow you to tighten them enough to prevent movement so I recommend not using a washer there.</p> <p><a href="https://a360.co/3241yyP">https://a360.co/3241yyP</a> <a href="https://a360.co/38DJwpp">https://a360.co/38DJwpp</a> <a href="https://a360.co/2HtrM4f">https://a360.co/2HtrM4f</a> <a href="https://a360.co/323fY1Q">https://a360.co/323fY1Q</a> <a href="https://a360.co/2VanVBh">https://a360.co/2VanVBh</a> <a href="https://a360.co/2P1qIbI">https://a360.co/2P1qIbI</a> <a href="https://a360.co/37CcGUG">https://a360.co/37CcGUG</a></p> <p>Printed with 60% infill and 8 walls so the threaded parts had something to grab and there was sufficient structure for the clamping forces.</p> <p>The hex plug is for the tripod mounting piece, it gets glued in to keep the bolt in place.</p> Category: Gadgets