TRONXY X5 Nozzle Cleaner

thingiverse

This is a part that is designed to clean a nozzle on the TRONXY X5 after nozzle heating but prior to the print. It clamps to the front left column. I have also included a screenshot of the actual wire brushes I used in my assembly (I cut it down with hacksaw). You will probably want to redesign part of it to use whatever small wire brushes you can get hold of. Also included is a screenshot of the custom G Code I am using with Slic3r in Repetier (This may well be able to be optimised too) It also uses M5 and M6 cap screws so you will need to drill and tap out the holes to suit. (Initial holes are designed into the print, just need to be cleaned up with drill and tap) If there is sufficient interest I may design and upload a part with a flat face that any small wire brush can be glued to