Tronxy X5S RPI3B 3.5TFT with octopi or octoprint and touchui

thingiverse

This is a custom design for my Tronxy X5S. I combined two files to enable my RPI3 and TFT35" to be securely attached to it (my Quimat bracket works well, but any similar one should also do the trick). To attach the bracket to the Tronxy frame, you will need: 2x M4x10mm screws 2x M4 T-nuts for the 2020 V slot profile As it turns out, the bracket fits pretty snugly without any additional attachments. Simply clip it in place and you're good to go! I did make a modification to enlarge the holes on the cap for the USB and RJ45 ports. However, I'm still not entirely happy with the requirement of using glue to secure the cap, as it doesn't fit perfectly and tends to shift around.