TronXY X5S simple, reinforced, adjustable X/Y motor mounts

thingiverse

Simple X/Y motor mounts, easy to print and easy to install. The motor holes are slotted for adjustment, to help take up any remaining slack after tightening your belts by hand. These rely on the motors being installed and tightened down for some of their overall rigidity, so don't be alarmed if your prints seem like they might flex a little too much when you're just playing around with them. They'll be rock solid (well, OK... plastic solid) after everything is in place. I highly recommend using washers on the four M3 motor screws. The stock screws have very small heads, and can fairly easily pull through the slots when you're tightening them down. A washer makes everything better. I printed mine with a 0.2mm layer height and 60% infill, using regular Inland PLA. They have been very sturdy for me, but feel free to use whatever material and settings you think would be best for you. Inspirational credit for the mounts goes to DracenKnights. These models are very directly based on one of his designs (I'm not sure if they're uploaded here yet), but were modeled from scratch because I needed the CAD practice.