Tronxy X5SA anti wibbly wobbly table brace

thingiverse

My Tronxy X5SA was having problems with tall prints. I found the biggest cause of the table rocking, were screws being loose. (Check them all). But this piece is printed twice and attached to both sides of the platform. It will provide more support for the bearings on the z-rods. I found that friction holsd them in place just fine. I printed mine in PLA. If you print in something slippery like PTEG you might have to put a zip tie around them and the bar above them to keep them in place. I have included the Openscad file.